PLEASE NOTE: If you are using Touch Sensitive Switch (Westfalia pt.# 4021-0453-000) on the Start/Reset connect the RED wire to Start connection closest to Power connection and the Purple wire to Start connection closest to LED+ connection.

Remove old box cover and disconnect old circuit board.

Step 1: Connect 24 VOLTS AC to top 2 connector screws on right side marked 24VAC.

 
Step 2: Connect Solenoid wires to next 2 screws marked Relay/ Solenoid.


Step 3: Connect Sensor wires to bottom 2 screws marked Sensor.


Step 4: Connect Blue ended connectors to Start/ Reset switch.


Step 5: Connect Red ended connectors to Auto/ Manual switch.


Step 6: Insert Light into light lens assembly & Reinstall box cover.


Step 7: Operate Unit in same manner as old unit.

 

* All names and logos are copyright to their respective owners